How Much Does Tile Floor Installation Cost?

National cost guides put a complete tile floor at about $15 to $75 per square foot for materials and labor, with labor alone usually about $5 to $22 per square foot (RUBI, 2026). A basic installation starts at roughly $16 to $20 per square foot (Homewyse, 2026). For our tile floor work around Grand Rapids, an approximate figure is about $20 to $60 per square foot installed. Where a floor lands in that range depends mostly on the tile, the condition of the floor underneath, and whether old flooring has to come out first.
What is included in the cost of a tile floor?
A tile floor price covers more than setting tile. It usually includes removing the old flooring, checking and preparing the subfloor, any backer board or leveling, the setting mortar, cutting and laying the tile, grouting, sealing the grout, and finishing the transitions at doorways. Ask whether the tile itself is included or priced separately, since tile prices vary widely. When two quotes for the same floor are far apart, the difference is usually in the preparation, not the tile.
What makes a tile floor cost more?
The biggest variable is what is underneath. Tile needs a flat, stiff base, and in older Grand Rapids homes subfloor conditions vary widely and usually are not visible until the old flooring comes up. National guides put leveling at about $2 to $5 per square foot (RUBI, 2026). Tearing out old tile runs about $3 to $7 per square foot including disposal (RUBI, 2026). Older sheet vinyl and its adhesive can contain asbestos, so it should be tested before it is torn up.
The tile matters too. Large-format tile needs a flatter floor and more careful setting, and national guides put it at about $18 to $40 or more per square foot including basic floor prep (Flooring Clarity, 2025). Diagonal and herringbone layouts take more cuts and more tile; RUBI recommends ordering 15 to 20 percent extra for complex or diagonal layouts (RUBI, 2026). Rooms with many cuts around toilets, vanities, and doorways take more time per square foot than one open floor. Adding electric floor heat runs about $8 to $15 per square foot for the heating layer alone (Block Renovation, 2026). See heated tile floors.
How much does it cost to tile a bathroom or small floor?
For a rough idea, multiply the floor area by the range. At about $20 to $60 per square foot, a 40-square-foot bathroom floor works out to roughly $800 to $2,400, and a 150-square-foot kitchen to roughly $3,000 to $9,000, before any major subfloor repairs. Very small floors can come in higher per square foot, because setup and preparation take about the same time whatever the size of the room. Entryways, mudrooms, and laundry rooms are welcome; see small tile jobs and tile for entryways and mudrooms.
Is it cheaper to repair a tile floor than replace it?
Usually, when the tile itself is sound. If only the grout is cracked or stained, regrouting runs about $5 to $11 per square foot nationally (Block Renovation, 2026), far less than a new floor. If tiles are cracking or sounding hollow across the whole room, the problem is usually underneath, and replacing the floor is the lasting fix. See tile repair, why grout cracks in a tile floor, and when to replace tile instead of repairing it.
How do you compare tile floor estimates?
Get written estimates that spell out the same things: the square footage, removal of the old floor, the subfloor preparation, whether the tile is included, the grout and sealing, and the transitions at doorways. A low price that leaves out the preparation often costs more later, because most tile floor failures start under the tile. See how to tell if tile was installed badly for what to ask before you hire.
See tile floor installation, the tile section of our cost guide, or all of our tile contractor services. For homes in the city, see tile installation in Grand Rapids, or contact us for a free estimate. Tile floors are indoor work, so they can be scheduled through a Michigan winter.
Frequently Asked Questions
How much does it cost to install tile floor per square foot?
National cost guides put a complete tile floor at about $15 to $75 per square foot, with labor alone about $5 to $22 (RUBI, 2026). For our work around Grand Rapids, an approximate figure is about $20 to $60 per square foot installed, depending on the tile, the subfloor, and removal of the old floor.
How much does it cost to tile a bathroom floor?
At about $20 to $60 per square foot installed, a 40-square-foot bathroom floor works out to roughly $800 to $2,400 before any major subfloor repairs. Small floors can cost more per square foot, because setup and preparation take about the same time whatever the size of the room.
Does removing old tile add to the cost?
Yes. National guides put tearing out old tile at about $3 to $7 per square foot including disposal (RUBI, 2026). Removal also shows the condition of the subfloor, which can add leveling or repairs before the new tile goes down.
Is porcelain tile more expensive to install than ceramic?
Ceramic is often the less expensive choice. Porcelain is denser and absorbs less water, which suits entryways and mudrooms that see snow and salt. The installation work is much the same for both, so the subfloor and the size of the tile usually move the price more than the choice between them.
Need Professional Help?
If you've identified masonry issues or need a professional inspection, Grand Rapids Masonry & Restoration is here to help. We serve the Grand Rapids metro area and surrounding communities.
Related Articles

How Does Kitchen Tile Floor Installation Work in Grand Rapids Homes?
Kitchen tile floor installation starts with subfloor assessment — flatness, stiffness, and moisture — before tile is selected or set. Here is how the process works in Grand Rapids homes.

What Tile Works Best for Michigan Entryways and Mudrooms?
Entryway and mudroom tile needs slip resistance, durability against salt and moisture, and a flat substrate that handles seasonal tracking without cracked grout or lippage.

What Is the Best Tile for a Bathroom or Kitchen Floor?
Porcelain, ceramic, or natural stone? Here is how to choose floor tile for a bathroom or kitchen, which finishes are safer when wet, and why tile size changes what the floor underneath needs.
Tile Services in Greater Grand Rapids
Grand Rapids Masonry & Restoration handles indoor tile work year-round — showers, floors, backsplashes, repair, and replacement across the Grand Rapids metro.
View all tile contractor services →